Temporary Stairs

Made to Measure Open Plan Stairs for internal or external use

Do you need a low cost solution to gain good sturdy stair access to a first floor in a first fix stage building project? If so, this item is for you. It is a set of open plan stairs made to your width and height. Ideal for temporary stairs during first fix stage of construction or for any access purposes. Can also be used for commercial properties on a permanent basis. Made from graded kiln dried carcassing timber to keep prices low. We use 9x2" timbers for the treads and 8x2" for the strings which gives a strudy construction. They can be used externally in the garden. We will usually be able to dispatch the same day if ordered before 10am for next working day delivery. 

This item has  been priced up to the following specification:-

• Overall width (including strings) - 950mm
• Overall Rise - 2650mm
• Number of Treads - 12
• Tread Depth - 220mm
• Angle of stairs - 42 degrees
• All components  supplied loose 
• Delivered flat in flat pack form.
• All treads are cut to the appropriate length.
• The treads are made from 9x2"(nominal) treated timber.
• The strings are ,made from 8x2"(nominal) treated timber.
• Can be used internally or externally.
• Made from treated timber.
• Only treads and strings supplied. No balastrading or riser fillers are supplied.
• They are made to all building regulations apart from the 100mm gap between the treads which can be easily overcome. 
  

After we receive your information we will provide you with a price for the stairs and delivery.

Installation instructions.

We supply 4no. x 80mm x M5 woodscrews per tread.

• You will need a saw, adjustable bevel, square, pencil, sandpaper.
• Lightly, sand all the rough edges so they are free of spelching. Cut the ends of the strings so they create equal heights of rise between each tread, tread and floor. We recommend that the top tread is kept about 20mm away from the vertical surface you are fastening it to. This will leave enough timber on the string to locate the tread.
• If fitted externally, end seal any end grain on the end of the treads and in the string trenches and ends.
• Slide the Treads into the pair of strings with the bigger rounded edges, on the treads, to the back.
•  Screw 2 screws through the strings into each end of each tread. Each screw is to be positioned in the middle of each tread, 20mm from the edge.